4 comments

Add a comment…

Sign in

prestine

Your email address

Check!

invalid email

(thinking…)

Reset

or sign in with

• 
• 

UserVoice password

Forgot password?

Create a password

Your name

I agree to the terms of service

You'll receive a confirmation email with a link to create a password (optional).

Signed in as (Sign out)

Close

Close

Post comment Submitting...

• HaroldL commented  ·  July 11, 2011 10:49  ·  Flag as inappropriate  ·  Delete

  Can't believe this only has 15 votes.

• HaroldL commented  ·  July 11, 2011 10:48  ·  Flag as inappropriate  ·  Delete

  Adding a dimension during the Offset command is a MUST. Without a dimension added I may as well create a new sketch figure and dimension it without the Offset command. Offset is useless without an editable dimension and constraints added during the Offset creation.

• Jonathan Finch commented  ·  December 02, 2010 06:19  ·  Flag as inappropriate  ·  Delete

  I would think this would be a rather common thought. Dimensioning is the most tedious part of my designs, and quite often I am creating parts that maintain the same offset on multiple sides. I wouldnt mind if the offset feature was a constraint to the dimension you enter. Though I would preferr to be able to edit the offset as well.

• Gordon McDermott commented  ·  September 13, 2010 16:29  ·  Flag as inappropriate  ·  Delete

  It would be great if an offset line or arc maintained its offset distance automatically. Or at least add dimensions automatically, that could be edited if necessary.