8 comments

Add a comment…

Sign in

prestine

Your email address

Check!

invalid email

(thinking…)

Reset

or sign in with

• 
• 

UserVoice password

Forgot password?

Create a password

Your name

I agree to the terms of service

You'll receive a confirmation email with a link to create a password (optional).

Signed in as (Sign out)

Close

Close

Post comment Submitting...

• Tom Barnett commented  ·  April 18, 2012 20:48  ·  Flag as inappropriate  ·  Delete

  Also like the syste to support chains and belt systems. As a motorcycle manufacturer, this would be killer for me. Now I have a friend with Solidwork create the files for me. Not the most friendly.

• Lance Bailey commented  ·  December 04, 2011 14:56  ·  Flag as inappropriate  ·  Delete

  I too would like constraining ability within the assembly mode; I would also like there to be an ability to calculate the Ratios of 2 gears meshed together; plus the ability to calculate the final Ratio of a cluster of gears such as in a transmission all the way down to the differentials. In other words it would be able to calculate the final Ratio starting from the motor pinion thru the tranny and transfer case and down to the diff ring and pinion (final Drive Ratio).

• Matthew Cornelisse commented  ·  November 26, 2011 08:29  ·  Flag as inappropriate  ·  Delete

  this would be a huge help especially if could define a clearance value and auto constrain to the correct placement. The clearance value is to make 3d printing with moving parts easy.

• David Lillington commented  ·  August 17, 2011 02:59  ·  Flag as inappropriate  ·  Delete

  I agree with Justin.

• Justin commented  ·  May 19, 2011 02:06  ·  Flag as inappropriate  ·  Delete

  This will be a huge disappointment, unless you can constrain the gears to work properly. Like you can in solidworks

• Lance Bailey commented  ·  April 27, 2011 12:04  ·  Flag as inappropriate  ·  Delete

  I would like to see Gleason standard spiral bevel gear generation and Gleason standard hypoid gear generation; as well as helical gear generation.

• John A. Bodmer commented  ·  November 05, 2010 17:29  ·  Flag as inappropriate  ·  Delete

  I do a lot of engine designs, so a gear generator with both 14.5 and 20 degree pressure angles would be helpful

• LaVerne commented  ·  October 31, 2010 07:20  ·  Flag as inappropriate  ·  Delete

  I think you can add a sprocket generator to this as well!